GEDORE AUTOMOTIVE Spring compressor with protective inserts 5-piece 2909499

KL-9002 SP E Spring compressor with protective inserts, 5-piece. Springs on wishbone axles can also be removed and installed with the tool using special spring holders, provided space permits, Including pairs of spring holders size 1 and 2 for spring Ø of 85 mm (inside) - 170 mm (outside), Further spring holders available for spring Ø of 60 (inside) - 205 (outside) mm, Max load 27 500 N (with the prescribed 4-fold safety, the maximum load of the spring compressor is 27 500 N!), The universal spring compressor, - in which the minimum clamping width (opening width) can be changed to 40 mm and the maximum to 361 mm by means of a grid system, This is important when tensioning very short springs (2 - 3 spring coils) and very long springs in order to be able to fully relax or replace them, - in which the forged spring holder is fastened by a bayonet locking system with automatic locking (tools, screws and screw rings are not required), - in which the spindle drive remains closed if the locking pin shears off, The tensioned spring can then be released via an auxiliary drive in order to subsequently fit a new locking pin, - in which spindle overload during the release process is prevented by an automatic freewheel when the maximum working stroke is reached, - in which plastic protective inserts can be screwed to the spring holders to protect the surface of the spring coating, - in which plastic protective inserts can be screwed to the spring holders to protect the surface of the spring coating, important to prevent spring breakage due to notching and corrosion, - which can be used for almost all MacPherson strut axles, damper leg axles and, in some cases, wishbone axles thanks to a wide range of spring holders, The combination of high-precision individual components and the use of wear-resistant nitriding steel means that the tensioning cylinder runs very smoothly and is virtually wear-free, For example, when tensioning a Mercedes M-Class spring with a block force of approx. 18,000 N, a drive force of only 35 Nm is required, Advantages: - Easy to operate despite high forces, - Spring holder fastening with automatic engagement, - Clamping width adjustment, - Drive with additional auxiliary drive, - Automatic freewheel of the spindle, - Can also be used for conical springs, - Plastic protective inserts included. With the manufacturer's article number 2909499 and EAN code 4046459140566.